IFC 110 F V2.0 IFC 110 F-EEx V2.0 - Krohne

Part B IFC 110 F Signal converter Sect. 5.35.3 Low-flow cutoff SMUFct. 1.03 L.F. CUTOFFPress → keySelect• OFF (fixed tripping points: ON = 0.1 % / OFF = 0.2 %)• PERCENT (variable tripping points: ON = 1 - 19 % / OFF = 2 - 20 %)Select with keys ↑ and ↓ (only if PERCENT is selected).1st number (cursor) flashes.Setting the numerical value when ”PERCENT” is selected• 01 to 19 (cutoff ”ON” value, left of hyphen)• 02 to 20 (cutoff ”OFF” value, right of hyphen)Change flashing number (cursor) with keys ↑ and ↓ .Use → and ← keys to shift cursor 1 place to right or left.Flashing numbers (cursor) can also be directly set with the 10-key keyboard.Press ↵ key to return to Fct. 1.03 L.F. CUTOFF.Note: the cutoff ”OFF” value must be greater than the cutoff ”ON” value.5.4 DisplayFct. 1.04 DISPLAYPress → key→ DISP. FLOW = select unit for display of flow rate, press → key• NO DISP (no display)• m³/h (cubic metres per hour)• Liter/Sec (litres per second)• US.Gal/min (US gallons per minute)• User-defined unit, factory setting = ”Liter/h” (litres per hour) or ”US MGal/day”,see Section 5.14• PERCENT (percentage display)• BARGRAPH (numerical value and bar graph display in %)Select with ↑ and ↓ keys.Press ↵ key to change to subfunction ”DISP. TOTAL.”.→ DISP. TOTAL. = select unit for totalizer display, press → key• NO DISP. (no display)• OFF (internal totalizer switched off)• + TOTAL. • – TOTAL. • +/– TOTAL. • SUM. (Σ) • ALL (sequential)Select with ↑ and ↓ keys.Press ↵ key to change to display unit setting.• m³ (cubic metres)• Liter (litres)• US.Gal (US gallons)• User-defined unit, factory setting = ”Liter” (litres) or ”US MGal/day”, see Section 5.14Select with ↑ and ↓ keys.Use → key to change to totalizer format setting.05/2003 IFC 110 F 41