IFC 110 F V2.0 IFC 110 F-EEx V2.0 - Krohne

Part C Special applications, functional checks, service, and order numbers Sect. 6.4Electrical connectionHART ® - activenot with multidrop operationHART ® - passiveonly with multidrop operationactivepassiveto HART ® - communicatoror smart-converterto nextHART ® - devicepower supply unitBürde ≥ 230 Ωto HART ® - communicatoror Smart- converterPower supply unit (and section switch amplifier) must be set up accordingly if in use for HART ®operation. For setting active/passive operation see Sect. 6.8.Settings and operationFct. Parameter Point-to-point mode Multidrop mode1.05 Function 1 CORRECT. or 2 CORRECT. OFFRange I 4-20 mA or I 0% ≥ 4 mA I 0% ≥ 4 mA3.09 Communication HART HARTAddress 0 01, 02, 03 ..... 15(use one address atone time only)OperationCurrent output active or passive passive onlyFor further information on setting the signal converter refer to chapters 4 and 5.HART ® operating tools / Device Description (DD)The signal converter can be operated either via its local operator interface or by means of theHART ® communicator, which is available from KROHNE.Operator control by means of the HART ® communicator requires a device description (DD) whichwe can load for you into the communicator. We can, of course, also load the DDs of allmanufacturers who have filed their DDs with the HART ® Communication Foundation.If you wish to use the signal converter in your operating tool, for example, please ask for thedescription of the HART ® command used so that you can address the complete signal converterfunctionality via HART ® .05/2003 IFC 110 F 59