DIN EN 16001: Energy Management Systems in Practice - adelphi

More documents

Recommendations

Info

92 DIN EN 16001 Requirements ISO 14001 Chapter Chapter 3.5 Checking 4.5 Checking 3.5.1 Monitoring / measurement 4.5.1 Monitoring / measurement Requirements for monitoring, measuring and targeting shall be described (specifically for energy consumption) Accuracy and reuse of monitoring and measuring equipment Relationship between energy consumption and associated energy factors shall be established; assessment of actual vs. expected energy consumption at defined intervals Maintenance of records of significant accidental deviations from energy consumption that is expected Reviewing of relationship between energy consumption and energy factors at defined intervals Comparison of energy indicators against those of similar organisations Fulfilled by monitoring and measurement of processes with significant impact on environmental aspects Ensuring use of calibrated and / or verified monitoring and measurement equipment Not explicitly required Not explicitly required Not explicitly required Not explicitly required 3.5.2 Evaluation of compliance 4.5.2 Evaluation of compliance 3.5.3 Nonconformity, corrective action and preventive action 4.5.3 Nonconformity, corrective action and preventive action 3.5.4 Control of records 4.5.4 Control of records Records need to demonstrate performance achieved and effectiveness of EnMS, as well as define necessary controls 3.5.5 Internal audit 4.5.5 Internal audit Procedure(s) for identification, storage, protection, retrieval, retention and disposal of records shall be established, implemented and maintained EnMS conforms to all requirements of standard Audit to check conformance of environmental management system with arrangements for environmental management including requirements of standard, to determine whether environmental management system is properly implemented and maintained Check legal obligations Not explicitly mentioned, but fulfilled through a) Effectiveness of implementation and maintenance of EnMS Establishment of audit schedule and selection of auditors that ensure objectivity of audit Securing that actions are taken for elimination of nonconformities without hesitation Fulfilled through a) Auditor selection and conduct of audits need to ensure objectivity and impartiality of audit process Not explicitly mentioned
What should additionally be done with an existing ISO 14001? Generally included. Ensure that control also includes the monitoring of your energy consumption. Generally included. Ensure that the measurement equipment can also measure the specific energy consumption. Compare and assess the expected and actually measured energy consumption in planned time periods. Make available the records on significant unplanned deviations. Review the relationship between energy consumption and energy factors at regular intervals. Compare energy indicators with similar organisations. Generally included Generally included, in ISO 14001 it is examined more in detail than in DIN EN 16001. No substantial changes necessary. It should be ensured that all energy aspects are controlled effectively. Included; it should be ensured that the internal auditor has the knowledge required for energy management and energy efficiency. Generally included Generally included Generally included Generally included Ensure that measures to deal with nonconformity are immediately taken. 93
Page 1 and 2:
DIN EN 16001: Energy Management Sys
Page 3:
tAblE Of CONtENtS 1 fOREWORD 5 2 NA
Page 7 and 8:
2 NAvIGAtION For this guide, a navi
Page 9 and 10:
For integrating various management
Page 11 and 12:
Since the requirements are derived
Page 13 and 14:
5 INtRODuCtION tO ENERGy MANAGEMENt
Page 15 and 16:
R tHE MOSt IMPORtANt ASPECtS Of AN
Page 17 and 18:
6. Projection of climate policies A
Page 19 and 20:
The individual steps of the PDCA cy
Page 21 and 22:
Determine responsibilities of the t
Page 23 and 24:
R ExAMPlE Of AN ENERGy POlICy * Our
Page 25 and 26:
Furthermore, the employees that hav
Page 27 and 28:
It is recommended that the scope of
Page 29 and 30:
To be able to achieve this, you req
Page 31 and 32:
You can use various sources for rec
Page 33 and 34:
R OPERAtIONAl ENvIRONMENt PERfORMAN
Page 35 and 36:
An important objective of your EnMS
Page 37 and 38:
5. Energy objectives and targets R
Page 39 and 40:
R ExAMPlE fOR AN ENERGy ObjECtIvE t
Page 41 and 42: R NEW ObjECtIvES IN tHE AREA Of GRO
Page 43 and 44: R ENvIRONMENtAl StAtEMENt 2009 Of t
Page 45 and 46: DO In order to achieve the maximum
Page 47 and 48: Measures without investment mostly
Page 49 and 50: 2. for a successful EnMS, focus on
Page 51 and 52: ISO 14001 does not make a statement
Page 53 and 54: Apart from communicating to raise t
Page 55 and 56: Tip Monitoring documentation Combin
Page 57 and 58: Furthermore, the regular maintenanc
Page 59 and 60: Literature tip On the website of th
Page 61 and 62: The purchase of measurement equipme
Page 63 and 64: 3. take action if the energy policy
Page 65 and 66: When conducting the internal audit,
Page 67 and 68: 7 CERtIfICAtION, ASSESSMENt & ExtER
Page 69 and 70: External communication Receiving th
Page 71 and 72: Bundesministerium für Umwelt, Natu
Page 73 and 74: ANNEx A: ENERGy MANAGEMENt CHECklIS
Page 75 and 76: No.* Required Elements 14 Identific
Page 77 and 78: No.* Required Elements 41 The own p
Page 79 and 80: No.* Required Elements D.2 Assessin
Page 81: No. Required Elements Implementatio
Page 84 and 85: 84 DIN EN 16001 Requirements ISO 14
Page 97 and 98: ANNEx C: COMPARAtIvE tAblE DIN EN 1
Page 99 and 100: What should additionally be done in
Page 101 and 102: What should additionally be done in
Page 103 and 104: NOtES 103
show all

DIN EN 16001: Energy Management Systems in Practice - adelphi

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?