CV7300 Instruction Manual - TECO-Westinghouse Motor Company

14- Motor Auto-Tune Parameters
Function
Code No.
LCD
Display
Description Range/Code
4-20
Chapter 4 Software Index
Factory
Setting Remarks
14-0 (Stator Resistor) Stator Resistance (Ohms) ----- *3*5
14-1 (Rotor Resistor) Rotor Resistance (Ohms) ----- *3*5
14-2 (Equi Inductance) Equivalent Inductance (mH) ----- *3*5
14-3 (Magnet Current)
Magnetizing Current (Amps
AC)
----- *3*5
14-4 (Ferrite Loss) Ferrite Loss Conductance (gm) ----- *3*5
15- Drive Status and Function Reset
Function
Code No.
LCD
Display
Description Range/Code
Factory
Setting Remarks
15-0 (Drive Model) Drive Horsepower Code (See page 4-53) *3
15-1 (Software Version) Software Version ----- ----- *3
15-2 (Fault Log) Fault Jog (Last 3 Faults) (See page 4-53) ----- *3
15-3 (Elapsed Hours)
Accumulated Operation Time
(Hours)
0 - 9999 ----- *3
15-4
Accumulated Operation Time
(Elapsed Hr*10000)
(Hours X 10000)
0 - 27 ----- *3
15-5 (Elapsed Time Sel)
Accumulated Operation Time
Mode
15-6 (Reset Parameter) Reset Drive to Factory Settings
※Notes: *1 can be modified during operation
0000: Time Under Power
0001: Run Mode Time Only
1110: Reset for 50 Hz Motor
Operation
1111: Reset for 60 Hz Motor
Operation
1112: Reset PLC Program
*2 cannot be modified during communication
*3 do not change while making factory setting
*4 as parameter related to factory setting
*5 the parameter will be changed by replacing model (see descriptions of the
POSTSCRIPT 1)
*6 only available in V/F mode
*7 only for version 2.3 and above.
*8 only for version 2.4 and above.
*9 for 15HP of 220V class and 20HP of 440V class above
0000 *3
0000 *4