Perkins L4 Workshop Manual - L-36 Fleet
Perkins L4 Workshop Manual - L-36 Fleet
Perkins L4 Workshop Manual - L-36 Fleet
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Page C2 Starting the Engfne-cantinued<br />
With some applicatiou~, in addition to the hand<br />
pump, two electric push button switches, marked<br />
.. Heater" and .. Starter" respectivly, are mounted<br />
on the instrument panel or somewhere conveniently<br />
near to the engine controls. These are for starting<br />
the engine.<br />
an other applications, a starter engaging lever<br />
is provided instead of the button switch previously<br />
mentioned.<br />
In warm weather or if the engine bas been only<br />
recently stopped, open up the throttle and engage<br />
the starter motor.<br />
If the battery is sufficiently charged to turn the<br />
starter motor quickly, the engine should start.<br />
Cold Starting Equipment.<br />
In cold weather, if the engine bas been standing,<br />
the cold starting equipment should be used.<br />
See that there is fuel oil in the reservoir tank<br />
(if fitted).<br />
Turn on the supply tap to the hand pump<br />
lTnscrew the pump plunger and give it one<br />
stroke of about half an inch.<br />
Fig. C2. Plug Heater<br />
~ N<br />
Q<br />
~<br />
I~ ,-<br />
(..aio.<br />
Press the "Heater" switch for about half a<br />
minute (count forty fairly slowly). Then with<br />
the "Heater" switch still pressed, and the throttle<br />
fully opened, cngage the starter motor, at the<br />
same time giving short strokes on the hand<br />
pump.<br />
The engine should then start.<br />
If it does not, wait half a minute and try again.<br />
If the engine does not start at the third attempt,<br />
some fault is present and an examination should be<br />
made.<br />
NOTE : Always be sure that the starter 'pinion<br />
bas stopped revolving before re-engaging the<br />
starter motor, otherwise the starter ring or pinion<br />
may be damaged.<br />
Af ter using the hand pump, always make sure<br />
that the plunger is screwed down and the reed<br />
tap turned off, otherwise a leakage may occur<br />
with damaging results.<br />
Main Tank Supply.<br />
In certain fuel systems no separate tank is fitted.<br />
lnstead the hand pump draws fuel from thc<br />
final fuel filter.<br />
Fig. C3. Wiring Diagram