CCNA Complete Guide 2nd Edition.pdf - Cisco Learning Home

Copy 'c2500-is-l.123-18.bin' from server
as 'c2500-is-l.123-18.bin' into Flash WITH erase? [yes/no]yes
Erasing device... eeeeeeeeeeeeeeeeeeee ...erased
Loading c2500-is-l.123-18.bin from 172.16.0.2 (via Ethernet0): !!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
[OK - 16265152/16777216 bytes]
Verifying checksum... OK (0x40BF)
Flash copy took 0:09:10 [hh:mm:ss]
Router(boot)#
Router(boot)#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(boot)(config)#config-register 0x2102
Router(boot)(config)#^Z
Router(boot)#sh ver
Cisco Internetwork Operating System Software
IOS (tm) 3000 Bootstrap Software (IGS-RXBOOT), Version 10.2(8a), RELEASE
SOFTWARE (fc1)
Copyright (c) 1986-1995 by cisco Systems, Inc.
Compiled Tue 24-Oct-95 15:46 by mkamson
Image text-base: 0x01020000, data-base: 0x00001000
ROM: System Bootstrap, Version 5.2(8a), RELEASE SOFTWARE
Router uptime is 11 minutes
System restarted by reload
Running default software
cisco 2500 (68030) processor (revision N) with 14332K/2048K bytes of memory.
Processor board serial number 05534538 with hardware revision 00000000
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
ISDN software, Version 1.0.
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
1 ISDN Basic Rate interface.
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2101 (will be 0x2102 at next reload)
Router(boot)#reload
System configuration has been modified. Save? [yes/no]: no
Proceed with reload? [confirm]
- Note: Issue the boot system global configuration command if applicable.
209
Copyright © 2008 Yap Chin Hoong
yapchinhoong@hotmail.com