coM.sat ISDN Basic UMTS
coM.sat ISDN Basic UMTS
coM.sat ISDN Basic UMTS
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>coM</strong>.<strong>sat</strong> <strong>ISDN</strong> <strong>Basic</strong> <strong>UMTS</strong><br />
of your doctor or the manufacturer of the medical device.<br />
2.6 Measures to be taken in case of loss/theft<br />
If the <strong>coM</strong>.<strong>sat</strong> <strong>ISDN</strong> <strong>Basic</strong> <strong>UMTS</strong>, the cellular engines or the SIM cards used are lost,<br />
inform your network provider immediately to prevent any misuse.<br />
2.7 Transport<br />
The packaging ex works is designed to protect against mechanical damage and<br />
should be stored for any later transports. To avoid moisture conden<strong>sat</strong>ion, time must<br />
be allowed for the devices to slowly adapt to the ambient temperature (if they have<br />
been stored in an environment with differing temperature) before starting them up.<br />
2.8 Where to install the devices<br />
The devices should be installed so that they are protected against direct sunlight and<br />
heat. This increases both the reliability of the operation of the devices as well as their<br />
service life, as the components used are less thermally stressed.<br />
The devices should also only be used with the power supplies that they are supplied<br />
with or an original spare part.<br />
The cables to the devices should be installed so that they do not cause any physical<br />
risk. Power cables should be installed separate from the signal cables.<br />
The devices should only be installed by adequately trained personnel.<br />
2.9 Damage and repairs<br />
For safety reasons, the device should not be used in case of noticeable damage or if<br />
it has been exposed to moisture.<br />
Repairs to the device should preferably only be carried out by the manufacturer or<br />
their authorised agents. Should this not be possible at any time, the repair must be<br />
carried out by an adequately qualified person, whereby only original parts should be<br />
used.<br />
The device must be disconnected from the voltage supply before each repair.<br />
created: page: file:<br />
11/04/07 11 <strong>coM</strong><strong>sat</strong> <strong>ISDN</strong> <strong>Basic</strong> Manual <strong>UMTS</strong>.doc<br />
Note Protection Mark according to DIN 34!