coM.sat ISDN Basic UMTS
coM.sat ISDN Basic UMTS
coM.sat ISDN Basic UMTS
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>coM</strong>.<strong>sat</strong> <strong>ISDN</strong> <strong>Basic</strong> <strong>UMTS</strong><br />
Figure 32: NT Configuration<br />
This operating mode enables differences that may possibly occur between the clock<br />
pulses in the telephone network and in the <strong>coM</strong>.<strong>sat</strong> <strong>ISDN</strong> <strong>Basic</strong> <strong>UMTS</strong> to be avoided<br />
if the socket labelled “TE/Sync“ is connected with the NTBA connection of the public<br />
network. If the connected PBX is able to use a clock derived from the first TE port on<br />
the second TE port connected to the <strong>coM</strong>.<strong>sat</strong> <strong>ISDN</strong> <strong>Basic</strong> <strong>UMTS</strong> and the optional<br />
add-on board for NT synchronization is installed, the TE/Sync port connection may be<br />
omitted if the “Sync from” configuration is set to “NT Port”. Note: Since the presence of<br />
the add-on board is not detected, the parameter field is always enabled in NT mode<br />
even if the add-on board is not employed.<br />
Correct installation of the TA can be identified from the LEDs. If the GSM/<strong>UMTS</strong><br />
modules have booked into the respective network, the green LEDs light up<br />
permanently. If one of the modules logs off from the network during operation, the<br />
corresponding green LED of this channel begins to flash slowly. The yellow LEDs are<br />
always off when no call is being made. While a connection is being set up they flash<br />
and they are permanently lit during a connection.<br />
Monitoring of the <strong>ISDN</strong> lines is switched on or off using the ”Enable <strong>ISDN</strong><br />
Watchdog” check box. If the box is checked, the monitoring is active on. A reset is<br />
created: page: file:<br />
11/04/07 73 <strong>coM</strong><strong>sat</strong> <strong>ISDN</strong> <strong>Basic</strong> Manual <strong>UMTS</strong>.doc<br />
Note Protection Mark according to DIN 34!