coM.sat ISDN Basic UMTS

coM.sat ISDN Basic UMTS
the “OK“ button pressed in the “Install from Disc“ window that is now in the
foreground.
The “Install New Modem“ window is now in the foreground and the list box of
modems includes the coM.sat ISDN Basic UMTS. After pressing the “Next“ key the
serial port (e.g. COM port (COM 1)) must be selected, via which the communications
with the coM.sat ISDN Basic UMTS are to be made later. If “Next“ is then clicked on
in this window, the modem is installed. The end of the installation is confirmed by the
message “The modem is now configured“ and concluded by pressing the “Finish“
button. The coM.sat ISDN Basic UMTS is now included in the Modem Properties
window.
Figure 37: Install modem
Then the fax program can be installed by following the manufacturer’s instructions
and documentation. When entering the modem to be used, select coM.sat ISDN
Basic UMTS.
Note: Within the WinFax Pro application, the best results were achieved when
transmitting fax messages to the coM.sat ISDN Basic UMTS when the ECM for
receiving option and the High Speed Compression (2D) option were switched off and
the maximum baud rate was set to 9600 Bd.
4.5.2 Send fax messages
created: page: file:
11/04/07 80 coMsat ISDN Basic Manual UMTS.doc
Note Protection Mark according to DIN 34!