LINC Programming Reference Manual - Public Support Login - Unisys

SEND.PRINT (SEND, SP)
Syntax
SEND.PRINT (SEND, SP)
The SEND.PRINT; command enables a Report to be output to multiple destinations. It is
applicable only to Standard Reports printed under the Report Output Control System
(ROC). It is ignored for ROC Direct Reports (and, on MCP based LINC Systems, all Reports
that do not use ROC). A SEND.PRINT; command must come after the first PRINT.FRAME;
command for a Report.
Output to the specified device or devices does not commence until a RELEASE; command
(or end-of-job) is encountered. If directed to a video device, output must be explicitly
requested by the receiving terminal through the ROC menu.
The System Data item GLB.STATUS is set to ***** if invalid device types or destinations
are specified, or if no output has been produced by the Report. Otherwise, GLB.STATUS is
set to spaces upon completion of the SEND.PRINT; command.
This command is ignored in LDA Run Time.
DD DBDDDDDDDDDDDDDDDDDDDDDDDDBD DD
3 3
@D DD DY
DDDBDDDDDDDDDDDDDDDDDBDDDBDDDDDDDDDDDDDDDDDDDDDBDDDD4
3 3 3 3
@DD DDY @DD DD DDY
device
A two-character value (without enclosing parentheses) or a data item containing a
two-character value giving the output device type. Valid values for each runtime host type
are shown in the following tables.
Device Host Types Output is sent to
LP MCP
environment
Line Printer
OS 2200
environment
User-defined Line Printer
UNIX Piped to a command defined by the LP alias
continued
v 1-215