LINC Programming Reference Manual - Public Support Login - Unisys

System Data Item Descriptions
LENGTH = 10 EDIT = A
GLB.REPNAME
GLB.REPORT
In Report logic, the value of this read-only System Data item gives the name of the Report.
LENGTH = 10 EDIT = A
GLB.REPORT is a System Data item that is included in all Event records, for use as a status
flag in Reports. Its value can be changed by using the FLAG; command.
This item is provided for general-purpose developer use. It is not used or affected by any
automatic LINC processes.
LENGTH = 1 EDIT = A
GLB.REPUNIQUE
Note: This System Data item is valid for MCP based LINC Systems only.
GLB.REPUNIQUE is a read-only System Data item automatically set by the LINC System to
provide a unique number for each Report at run time. Use of this System Data item is not
recommended and the preferred method is to use the RUN; command with the PA;
parameter.
If the Report is initiated from the Report Initiation Program (RIP) you must supply the
unique number that has to be passed to the Report in GLB.REPUNIQUE. By matching this
number against the first 15 characters of the GLBPAK filename, the LINC System identifies
the GLBPAK filename to RIP. The first 15 characters of GLBPAK filename must be numeric.
Enter the Report name and the unique number for GLB.REPUNIQUE as follows:
Here report is the name of the Report, and number is the unique 15-digit number. GLBPAK
must have a filename that contains only numbers for the first 15 characters.
LENGTH = 15 EDIT = N
2-50 v