LINC Programming Reference Manual - Public Support Login - Unisys

GLB.REPVERSION
System Data Item Descriptions
GLB.REPVERSION is a read-only System Data item that can be accessed in Report logic to
obtain the current version number of a Report. This number is incremented every time you
generate the Report. To cause this number to be reset to one when you generate your LINC
system with a new version id, enter Y in the Reset Report counts on system generate
field on the Change Control Options screen. You can also change it directly by using the
Supervisor RESET VER command.
GLB.REQUEST
GLB.REPVERSION is not implemented in LDA Run Time.
LENGTH = 4 EDIT = N
GLB.REQUEST is a read-only System Data item for use in Pre-Screen Ispec logic and
applies to Ispecs and Global Logics. It contains the value Y if the Ispec format was
requested from page 2 of the terminal, or a space if the Ispec format was requested from
logic.
GLB.ROCFLAG
LENGTH = 1 EDIT = A
GLB.ROCFLAG is a read-only System Data item used in Ispec and Report logic. It shows
whether or not LINC Report Output Control System (ROC) is set. It contains the value R if
ROC is set, or a space if ROC is not set.
LENGTH = 1 EDIT = A
GLB.SAVEDAYS
GLB.SAVEDAYS holds the number of days that Report output is to be retained by the LINC
Report Output Control System (ROC). The output will be deleted when this time has
elapsed, and when there are no outstanding requests for it to be printed. A value of 99
means the output is retained indefinitely.
GLB.SAVEDAYS has no effect for Direct Reports (and MCP based non-ROC Reports), and
is invalid in Ispec logic. It is not implemented in LDA Run Time.
v 2-51