Evolution Technical Manual - Jemphrey
Evolution Technical Manual - Jemphrey
Evolution Technical Manual - Jemphrey
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Technical</strong> <strong>Manual</strong><br />
3. Once all of the water has drained from the tank, replace the bung into the drain<br />
hose. Introduce the de-scaling solution in the recommended dosage into the<br />
heater tank. Switch on the machine and allow the heater tank to fill.<br />
4. Turn off the machine and leave for approximately 40 minutes before draining the<br />
tank again following the sequence described above.<br />
5. Fit a new water filter and switch on the machine. Fill the tank and drain again until<br />
all traces of the de-scaler are removed (at least 3 times).<br />
6. Switch on the machine and allow the heater tank to fill and to heat up. Drain and<br />
fill one more time. The machine is now ready to be put back in service.<br />
10.3 Brewer Maintenance - Freshbrew Machines Only<br />
Freshbrew machines are fitted with either a dual brewer unit which produces<br />
freshbrew coffee and tea beverages from the same unit, a single chamber paper less<br />
unit or a single chamber paper type unit. Routine cleaning and maintenance instructions<br />
for these units can be found in the <strong>Evolution</strong> Operators <strong>Manual</strong> - Part No. PR10908000.<br />
1. Removing The Brewer - Paperless Type<br />
1. Open the door and insert the safety key. The machine is now on.<br />
2. Using the service keypad mounted inside the door (see page 62), press and hold<br />
switch 2 until the brewer indexes to its fully open position. Remove the safety<br />
key to turn the power off. Remove the brewer guard to gain access to the brewer<br />
unit.<br />
3. Carefully remove both the coffee and tea water inlet pipes (dual brewer)/water<br />
inlet pipe (single brewer). Remove the dispense pipe(s) from the brewer unit. Pull<br />
down the spring loaded brewer release pin and carefully remove the brewer unit<br />
from its locating bracket.<br />
2. Removing The Filter Mesh Assemblies - Paperless Brewer<br />
Both the coffee brewer and tea brewer (dual unit) contain fine screen mesh assemblies<br />
which ensure coffee and tea vends are produced to the highest standards. To remove<br />
the mesh assemblies, proceed as follows:<br />
1. Remove the brewer unit from the machine as previously described and place on a flat<br />
surface. Lift the latch bar and remove the brewer chambers/wipe arms assembly.<br />
2. Removing the coffee filter mesh: Using the coffee filter extractor tool, part<br />
95