Quality and Reliability Methods - SAS

Chapter 12 Ishikawa Diagrams 205
Building a Chart Interactively
Other Menu Options
Change Type
changes the entire chart type to Fishbone, Hierarchy, or Nested.
Uneditable
disables all other commands except Move and Change Type.
Text Wrap Width
brings up a dialog that lets you specify the width of labels where text wrapping occurs.
Make Into Data Table converts the currently highlighted node into a data table. Note that this can be
applied to the whole chart by applying it to the uppermost level of the chart.
Close
Delete
is a toggle to alternately show or hide the highlighted node.
deletes the highlighted node and everything below it.
Drag and Drop
Nodes in a Diagram can be manipulated by drag and drop. Grab any outlined section of a Diagram and
drag to a new location. Use the highlighted bar as a guide to tell you where the node will appear after being
dropped.
For example, the following picture shows the element Setup (initially a child of Temperature) being dragged
to a position that makes it a child of Solder Process. Setup is then equivalent to Flux, Splatter, and Chain
Speed.
Figure 12.18 Dragging an Element
The next example shows two ways to make the Inspection tree a child of the Solder Process tree. Note that
both drag operations result in the same final result.