csmstr - Omega Engineering

CONFIGURING DATA TAGS
EDITING MULTI TAGS
THE ALARM TABS
Each Alarm tab of a multi variable or formula contains the following properties...
• The Event Mode property is used to indicate the logic that will be used to decide
whether the alarm should activate. The table below lists the available modes.
MODE
State Match
State Mismatch
ALARM WILL ACTIVATE WHEN…
The value of the tag is equal to the alarm’s Value.
The value of tag is not equal to the alarm’s Value.
• The Value property is used to define the comparison data for the alarm.
• The remainder of the properties are as described for the Alarms tab of flag tags.
THE TRIGGERS TAB
The Triggers tab of a multi variable or formula contains the following properties...
• The Trigger Mode property is as described for the Alarm tabs.
• The Delay property is as described for a flag tag’s Alarms tab.
• The Action property is used to indicate what action should be performed when
the trigger is activated. Refer to the Writing Actions section for a description of
the syntax used to define the various actions that Crimson supports.
REVISION 6 PAGE 125