csmstr - Omega Engineering

QUICK START
MAPPING DATA
To create a Gateway Block, click PLC1, and then click the Add Gateway Block button on the
right hand pane. This creates a single gateway block for mapping data…
Next, you’ll need to identify the register locations that you wish to map data to or from,
starting with a register address. Click the Edit button to see the registers supported by
Crimson for the selected protocol…
Enter the desired number of registers in the Block Size property, as well as the desired
direction using the Direction property.
In our example below, registers N7:0 through N7:16 have been allocated.
REVISION 6 PAGE 5