csmstr - Omega Engineering

MODULE CONFIGURATION
CSINI/CSINV – ANALOG INPUT MODULE PROGRAMMING
LINEARIZATION CURVE
The Linearization Curve plots the PV value over the input points. To enter new values, click
anywhere on the graphic.
CHANNEL N LINEARIZATION DATA
Enter up to 100 input/PV pairs for the selected input channel. Use a comma or to
separate the pairs, and press the enter key to enter the next pair. The graphic will update to
show the result of the data. Data may also be copied from programs such as MS Excel, and
pasted into the dialog box.
AVAILABLE DATA
The following are the data values available to the Master, and therefore, may be mapped to
PLC registers.
INPUT/STATUS
DATA DESCRIPTION RANGE ACCESS
PV1 – 8
Process Value – scaled according to PV at Minimum and
PV at Maximum values
* R
InputAlarm1 – 8 Input out of range 0 or 1 (bit) R
* Configuration dependent.
INPUT/CONTROL
DATA DESCRIPTION RANGE ACCESS
InputFilter Input Filter 0 – 60.0 sec R/W
ProcessMin1 – 8 Desired PV at minimum input signal level +/- 30,000 R/W
ProcessMax1 – 8 Desired PV at maximum input signal level +/- 30,000 R/W
LinearSlope1 – 8** Slope value applied to PV .001 – 10.000 R/W
LinearOffset1 – 8** Offset value applied to PV +/- 30,000 R/W
** Models with linearizer only.
REVISION 6 PAGE 55