csmstr - Omega Engineering

CONFIGURING THE MONOCHROME VIRTUAL HMI
ACTION DESCRIPTIONS
• The Write To property is used to define the data item to be changed.
• The Data property is used to define the data to be written.
In the example above, the key will set the MotorSpeed tag to 100.
THE RAMP INTEGER VALUE ACTION
This action is used to increase or decrease a data item. The options are shown below…
• The Write To property is used to define the data item to be changed.
• The Data property is used to define the step by which to raise or lower the item.
• The Limit property is used to define the minimum or maximum data value.
• The Ramp Mode property is used to define whether to raise or lower the item.
In the example above, holding the key will raise MotorSpeed by 1 until it reaches 100.
THE PLAY TUNE ACTION
This action plays a selected tune using the Master’s internal sounder.
REVISION 6 PAGE 153