csmstr - Omega Engineering

QUICK START
DOWNLOADING
In the example above, each of the first module’s input values have been mapped to registers
N7:0 through N7:7. The direction of the arrows indicates that the Modular Controller will
write these values into the PLC.
Next, another block is created to move data from the PLC to the Modular Controller. This is
done by changing the block’s Direction property to Device to MC. In the example below,
Module1’s offset values are mapped to registers N11:0 through N11:7. The Direction
property indicates that the MC will get the value from the PLC registers, and write them into
the module’s offset values.
DOWNLOADING
To download to the Master via serial is trivial. Simply make sure you’ve selected the proper
COM port under Link-Options.
REVISION 6 PAGE 7