csmstr - Omega Engineering

CONFIGURING THE COLOR VIRTUAL HMI
PRIMITIVE DESCRIPTIONS
More than one remote display is programmable on a single screen as each can have a single
unit address. The properties of the remote display are available when double clicking the
primitive.
• The Model defines the type of slave display the graphical area will be sent to.
The big flexible display will cover an area of 128 x 64 pixels on the screen
where the Little Flexible Display will cover 128 x 16 pixels.
• The Port points to the serial communication port number where the large display
for this primitive will be connected. Port numbers starts at one with the
communication port.
• The address is the large display node address this primitive will send the
information to. Please refer to the large display documentation to find the
address required.
THE CAMERA PRIMITIVE
The Camera Primitive is used to display the incoming image from a Banner
PresencePlus series camera.
This primitive is used in combination with the Banner PresencePlus Camera Ethernet port
driver. This driver is selected in Communication. More than one camera can be connected to
the operator interface. Properties are accessed by double clicking the primitive.
REVISION 6 PAGE 199