csmstr - Omega Engineering

MODULE CONFIGURATION
CSDIO – DIGITAL I/O MODULE PROGRAMMING
WORKING WITH SYMBOLS
You can select any symbol from the top of the page by left clicking on it. To place the
symbol(s) on the screen, simply left-click anywhere on the workspace. When you have
finished placing a particular symbol, right-click to deselect placement mode. Symbols can be
moved by selecting them with a left-click, and then by dragging them to the new position. A
subsequent left-click places the symbol in the new position. Most symbols have one or more
parameters that can be adjusted. Double-click the symbol in question to access its parameters.
Symbols are deleted by right clicking on them.
WORKING WITH WIRES
Wires are drawn using the left mouse button. Simply click on one connection point, and
then the next to draw the connection. The connection points will route automatically, but
you will sometimes find it necessary to move the wires to prevent overlap. The horizontal
sections can be moved by repositioning the symbol, while the vertical sections can be
moved by left-clicking them. Move the section to the desired area, then left click again to
place it.
SYMBOL DESCRIPTIONS
SYMBOL
DESCRIPTION
The logical AND requires that all inputs be active for an output of 1. To add more
inputs to the symbol, double-click it, and enter a new number.
The logical OR requires that one or more inputs be active for an output of 1. To
add more inputs to the symbol, double-click it, and enter a new number.
The logical XOR (exclusive OR) requires that one, but not all inputs, be active for
an output of 1. To add more inputs to the symbol, double-click it, and enter a new
number.
The Inverter simply reverses the state of the input.
REVISION 6 PAGE 61