GA-EX58-UD3R - Hardware

B. Installing Windows Vista
(The procedure below assumes that only one RAID array exists in your system.)
Intel ICH10R SATA controllers:
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation
steps. When a screen similar to that below appears, select Load Driver (Figure 4).
Figure 4
Step 2:
Insert the motherboard driver disk (Method A) or the floppy disk/USB flash drive that contains the driver
(Method B), then specify the location of the driver (Figure 5). Note: For users using a SATA optical
drive, be sure to copy the driver files from the motherboard driver disk to a USB flash drive before
installing Windows Vista (go to the BootDrv folder and save the whole iMSM foler to the USB flash
drive). Then use Method B to load the driver.
Method A:
Insert the motherboard driver disk into your system and browse to the following directory:
\BootDrv\iMSM\32Bit
For Windows Vista 64-bit, browse to the 64Bit folder.
Method B:
Insert the USB flash drive containing the driver files and browse to \iMSM\32Bit (for Windows Vista 32-
bit) or \iMSM\64Bit (for Windows Vista 64-bit).
Figure 5
GA-EX58-UD3R Motherboard - 92 -