GA-EX58-UD3R - Hardware

More documents

Recommendations

Info

B. Installing Windows Vista (The procedure below assumes that only one RAID array exists in your system.) Intel ICH10R SATA controllers: Step 1: Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps. When a screen similar to that below appears, select Load Driver (Figure 4). Figure 4 Step 2: Insert the motherboard driver disk (Method A) or the floppy disk/USB flash drive that contains the driver (Method B), then specify the location of the driver (Figure 5). Note: For users using a SATA optical drive, be sure to copy the driver files from the motherboard driver disk to a USB flash drive before installing Windows Vista (go to the BootDrv folder and save the whole iMSM foler to the USB flash drive). Then use Method B to load the driver. Method A: Insert the motherboard driver disk into your system and browse to the following directory: \BootDrv\iMSM\32Bit For Windows Vista 64-bit, browse to the 64Bit folder. Method B: Insert the USB flash drive containing the driver files and browse to \iMSM\32Bit (for Windows Vista 32- bit) or \iMSM\64Bit (for Windows Vista 64-bit). Figure 5 GA-EX58-UD3R Motherboard - 92 -
Step 3: When a screen as shown in Figure 6 appears, select Intel(R) ICH8R/ICH9R/ICH10R/DO SATA RAID Controller and click Next. Figure 6 Step 4: After the driver is loaded, select the RAID/AHCI drive(s) where you want to install the operating system and then click Next to continue the OS installation (Figure 7). Figure 7 - 93 - Appendix
Page 1 and 2:
GA-EX58-UD3R LGA1366 socket motherb
Page 3 and 4:
Copyright © 2008 GIGA-BYTE TECHNOL
Page 5 and 6:
Chapter 3 Drivers Installation ....
Page 7 and 8:
GA-EX58-UD3R Motherboard Layout KB_
Page 9 and 10:
Chapter 1 Hardware Installation 1-1
Page 11 and 12:
Internal Connectors • 1 x 24-pin
Page 13 and 14:
1-3 Installing the CPU and CPU Cool
Page 15 and 16:
1-3-2 Installing the CPU Cooler Fol
Page 17 and 18:
1-4-2 Installing a Memory Before in
Page 19 and 20:
1-6 Back Panel Connectors PS/2 Keyb
Page 21 and 22:
1-7 Internal Connectors 1 3 23 5 2
Page 23 and 24:
3/4/5) CPU_FAN / SYS_FAN1 / SYS_FAN
Page 25 and 26:
9) SATA2_0/1/2/3/4/5 (SATA 3Gb/s Co
Page 27 and 28:
13) F_PANEL (Front Panel Header) Co
Page 29 and 30:
16) SPDIF_I (S/PDIF In Header, Red)
Page 31 and 32:
20) COMA (Serial Port Header, White
Page 33 and 34:
Chapter 2 BIOS Setup BIOS (Basic In
Page 35 and 36:
2-2 The Main Menu Once you enter th
Page 37 and 38:
2-3 MB Intelligent Tweaker(M.I.T.)
Page 39 and 40:
CPU Thermal Monitor (Note) Enables
Page 41 and 42: Advanced Clock Control CPU Clock Dr
Page 43 and 44: Channel A/B/C Advanced Timing Contr
Page 45 and 46: ******* Advanced Voltage Control **
Page 47 and 48: 2-4 Standard CMOS Features CMOS Set
Page 49 and 50: 2-5 Advanced BIOS Features CMOS Set
Page 51 and 52: 2-6 Integrated Peripherals CMOS Set
Page 53 and 54: When LAN Cable Is Functioning Norma
Page 55 and 56: Resume by Alarm Determines whether
Page 57 and 58: Current Voltage(V) Vcore / DDR15V /
Page 59 and 60: 2-11 Set Supervisor/User Password C
Page 61 and 62: Chapter 3 Drivers Installation •
Page 63 and 64: 3-4 Contact Click the URL on this p
Page 65 and 66: Chapter 4 Unique Features 4-1 Xpres
Page 67 and 68: D. Using the Restore Function in Xp
Page 69 and 70: B. Updating the BIOS When updating
Page 71 and 72: 4-2-2 Updating the BIOS with the @B
Page 73 and 74: 4-4 Dynamic Energy Saver Advanced G
Page 75 and 76: 4-5 Q-Share Q-Share is an easy and
Page 77 and 78: Chapter 5 Appendix 5-1 Configuring
Page 79 and 80: C. Configuring a RAID array in RAID
Page 81 and 82: Step 5: Enter the array capacity an
Page 83 and 84: 5-1-2 Configuring GIGABYTE SATA2 SA
Page 85 and 86: Create a RAID Array: In the main sc
Page 87 and 88: When finished, the new RAID array w
Page 89 and 90: 5-1-3 Making a SATA RAID/AHCI Drive
Page 91: For GIGABYTE SATA2 SATA controller:
Page 95 and 96: Step 3: When a screen as shown in F
Page 97 and 98: Performing the Rebuild in the Opera
Page 99 and 100: Rebuilding in the operating system
Page 101 and 102: Step 2: Connect an audio device to
Page 103 and 104: B. S/PDIF Out: The S/PDIF out jacks
Page 105 and 106: Step 4: To raise the recording and
Page 107 and 108: 5-3 Troubleshooting 5-3-1 Frequentl
Page 109 and 110: A When the computer is turned on, i
Page 111 and 112: Finally, we suggest that you practi
Page 113 and 114: - 113 - Appendix
Page 119 and 120: Contact Us • GIGA-BYTE TECHNOLOGY
show all

GA-EX58-UD3R - Hardware

Create successful ePaper yourself

Delete template?

Save as template?