Catalog LV 70 2011 - Low & Medium Voltage - Siemens

© Siemens AG 2011
BD01 System — 40 ... 160 A
Introduction
Tap-off units for free arrangement of components
• One size with 3 MW space requirement (1 MW = 18 mm), for
operation from the outside through a hinge switch integrated
in the cover.
• Installation of devices (e.g. miniature circuit breakers) according
to DIN 43871 up to and including 32 A possible
Tap-off units for free arrangement of components
• Two sizes with 4 MW and 8 MW space requirement
(1 MW = 18 mm; MW = modular width)
• Without or with device installation unit for external actuation
(two sizes with 4 MW and 8 MW)
• Installation of devices (e.g. miniature circuit breakers) according
to DIN 43871 up to and including 63 A possible
BD01-AK02M0/F
Tap-off units made of aluminium
Common features
• The enclosure is made from aluminum and molded plastic at
both ends.
• A standard mounting rail is built-in for component mounting.
• Power pick-up through silver-plated lyre-shaped contacts
• The isolator built into the tap-off unit ensures that the tap-off
unit is voltage-free when the cover is open.
• The tap-off unit can only be fitted to or removed from the tapoff
point with its cover open (contacts retracted).
• Reliable prevention of incorrect mounting
• Cable entry is possible from three directions (use plastic cable
glands with strain relief; not included in scope of supply).
• Can be combined with ancillary equipment units for additional
functions.
• The connecting cables should be supported separately if necessary.
Tap-off units with components fitted
• Two sizes with 4 MW or 8 MW space requirement
(1 MW = 18 mm)
• Various versions with fuse bases, miniature circuit breakers up
to and including 63 A, with SCHUKO and CEE socket outlets
up to and including 32 A
• Versions with fitted miniature circuit breaker have a device
installation unit.
BD01-AK1M1/F
Country-specific tap-off units
These tap-off units contain equipment according to typical national
requirements, such as special socket outlets.
Ancillary equipment units
The ancillary equipment units are used for expanding the tap-off
units or infeeds used. They can be mounted to the side of them.
Common features
• The enclosure is made from aluminum and molded plastic at
both ends.
• Cable entry is possible from four directions (use plastic cable
glands with strain relief; not included in scope of supply).
• The connecting cable should be supported separately if necessary.
• Can be combined with tap-off or feeder units
• A standard mounting rail is built-in for component mounting.
• Two sizes with 4 MW and 8 MW space requirement
(1 MW = 18 mm)
• Without or with SCHUKO or CEE socket outlets
• Without or with device installation unit for external operation
(two sizes with 4 MW and 8 MW)
• Installation of devices (e.g. fuse bases) according to
DIN 43871 up to and including 35 A possible.
4
BD01-AK1M1/A163
BD01-GK2X/F
NSV0_00056
NSV0_00319
NSV0_00057
NSV0_00058
NSV0_00055
NSV0_00077
BD01-AK2M1/ CEE165A163
BD01-GK1X/... (left) with BD01-AK2M2/... (right)
Siemens LV 70 · 04/2011
4/5