Girard Systems- Warranty and Freight Procedures

More documents

Recommendations

Info

® GIRARD SYSTEMS G-2000Automatic Lateral Arm Awning System G1500 Door Lateral Arm Awning System INSTALLATION MANUAL WARNING: Improperinstallation, adjustment, alteration, service, ormaintenance can cause injuryorpropertydamage. Carefullyreadmanualbefore beginning installation. Instructions subjectto change withoutprior notice. San Clemente CA . Tel: (800) 382-8442 . Fax: (949) 587-9680
--------------- GIRARD PRODUCT DESCRIPTION SYSTEMs" The G-2000 Automatic Lateral Arm Awning System provides perfectweather protection at the touch ofa button. Poweredby a single motor control, your unit features the windsensor control box, the windsensor anemometer, an attractive one-buttonwall mount switch which operates like a garage door opener, ten feet (10') oflow-voltage cabling, andincludes an integrated radio receiver plus a hand-heldremote transmitter!control (see below). With the addition ofthe Wind Sensor V with Remote to your awning installation, wind speeds will be continuously monitored, triggering the controls to retract the awning in event ofwinds above 22 mph. The control box is packaged in a weatherproofenclosure andincludes watertight strain-relieffittings for wires entering the box. Installation is quick and easy andincludes all necessary cabling. TheWind Sensor Vwith Remote uses a hand-held radio transmitterwhich features up, down, and stop buttons. The G-1500 Door System is a shorter version ofthe G-2000 Automatic LateralArm Awning System. Wind Sensor Control Box (E-2) ;::::::: ~ Anemometer (E-4) Anemometer (E-4A) Remote (E-5) / I~ I~ I~ III [tij ~~ IIIG III ~ if if / I ~ Four Channel Rocker Switch (E-3 Paddle Switch (E-7) RTS Remote Switch (E-8) if / INDEPENDENT COMPONENTS Girard Systems © 2005 31
Page 2 and 3: Girard Systems- Warranty and Freigh
Page 4 and 5: WARRANTY Girard Systems offers a Li
Page 6 and 7: Remote Switch 46 (Hardware Installa
Page 8 and 9: IMPORTANT OPERATION REMINDERS 1. Co
Page 10 and 11: B. REMOTE CONTROL (Programming) 1.
Page 12 and 13: FIGURE 3 RTS REMOTE SWITCH BATTERY
Page 14 and 15: GIRARD SYSTEMS G-2000/G-1500 ADJUST
Page 16 and 17: ADJUSTING MOTOR LIMIT SWITCHES (CON
Page 18 and 19: Loosen front bolt Pivot bolt / ~,?-
Page 20 and 21: The awning lead rail comes factory
Page 22 and 23: SECTION I ACCESSING THE MOTOR Beave
Page 24 and 25: 2) Place one person in front ofthe
Page 26 and 27: I. FABRIC REPLACEMENT RECESSED AWNI
Page 28 and 29: During this fabric installation and
Page 30 and 31: Important Note: Extreme CAUTION sho
Page 34 and 35: TOOLS REOUIRED --J --J --J --J --J
Page 36 and 37: INSTALLATION SEOUENCE 4.5 hours (ba
Page 38 and 39: ~ Diagram not to scale Minimum 51S"
Page 40 and 41: (- --:;':-,.>, 7/16" __ \. '\~:::::
Page 42 and 43: 2. Place awning onto brackets, ensu
Page 44 and 45: 3. Drill one 3/8" hole for anemomet
Page 46 and 47: 4. Ten feet (10') ofgray low-voltag
Page 48 and 49: Cl ~ ~ ~ ~~ @ ~ a ~ $ $ -. MOO _.l'
Page 50 and 51: --------------- GIRARD SYSTEMs" 1.
Page 52 and 53: --------------- GIRARD ACL current-
Page 54 and 55: -------------.,-~~ -""". -- .....~
Page 56 and 57: W. WEATHER STRIPPING (Installation)
Page 58 and 59: III. IV. MOTOR SPECIFICATIONS 1. Ty
Page 60 and 61: SOLUTION Open awning about three (3
Page 62 and 63: nuts located beside the arm connect
Page 64 and 65: PART NO. WHITE PART NO. BI ACK PART
Page 66 and 67: ,------ ,- @:~~-_llt-, , / ' , , I;
Page 68 and 69: 5 ~ 52 51 53 96 © 36~ 22 ~.~; .. \

Girard Systems- Warranty and Freight Procedures

Create successful ePaper yourself

Delete template?

Save as template?