Girard Systems- Warranty and Freight Procedures
Girard Systems- Warranty and Freight Procedures
Girard Systems- Warranty and Freight Procedures
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
2. While cover is offcontrol box, take specific note ofwind speed setting (Fig. 33 callout,<br />
"Wind Adjustment"). The arrow should be pointing atthe 3:00 position (factory pre-set at<br />
22 mph). To adjust the pre-set wind speed, rotate the dial to the preferred setting. The<br />
minimum setting is 12 mph; maximum setting is 31 mph.<br />
GIRARD SYSTEMS STRONGLY RECOMMENDS NOT SETTINGTHE DIAL<br />
OVER 26 MPH. DISREGARDINGTHIS WARNING MAY VOID WARRANTY.<br />
Wind Speed<br />
Setting Dial<br />
o<br />
SOMFY IlECOMMENDS<br />
WIRING LOW VOLTAGE FIRST<br />
12 17<br />
~22<br />
31 26<br />
MPH<br />
WIND ADJUSTMEN<br />
WIND<br />
SENSOR<br />
FIGURE 33<br />
CONTROL BOX (INTERNAL) WITH WIND SPEED SETTING DIAL<br />
o. AWNING MOTOR CORD AND ACL-G CURRENT-LIMITING DEVICE<br />
(Electrical Installation)<br />
1. Take end ofawning motor cordwire(s) <strong>and</strong> cut offa portion long enough to connectthe<br />
48 <strong>Girard</strong> <strong>Systems</strong> © 2005