Dolby CP750 Digital Cinema Processor Manual - Projectionniste.net
Dolby CP750 Digital Cinema Processor Manual - Projectionniste.net
Dolby CP750 Digital Cinema Processor Manual - Projectionniste.net
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Introduction<br />
1.3.7 Automation Connector<br />
This connector is used to select an audio input, to read back the currently‐selected input,<br />
and to remotely assert the mute command. The pinout is listed in Section 7.2.5.<br />
The automation subsystem is referenced to pin 12, Automation Return. This is the ground<br />
for these functions, and is connected to the ground of the <strong>CP750</strong> only through a 1 k<br />
resistor. An isolated power supply is provided so that connection to automation systems<br />
can be made without introducing hum due to ground loops.<br />
Caution: The isolated power supply can only function properly if the Automation Return<br />
pin is within ± 5 Volts DC (or peak AC) of the <strong>CP750</strong> chassis ground.<br />
The automation control system is designed to accept contact closure inputs. A closed<br />
contact asserts a command. The low side of the contact closing switch or relay should be<br />
connected to Automation Return.<br />
Warning: UNDER NO CIRCUMSTANCES should power from an external source be<br />
supplied to any pin in this connector! Connecting external power is likely to<br />
damage the <strong>CP750</strong>.<br />
1.3.8 1xAES IN Connectors<br />
These BNC connectors are linked to the <strong>Digital</strong> 2 and <strong>Digital</strong> 3 buttons. They accommodate<br />
PCM audio at 96, 48, and 44.1, and 32 kHz (16, 20, and 24 bits) and <strong>Dolby</strong> <strong>Digital</strong> at all data<br />
rates and sample rates. A BNC male to RCA female adapter can interface with most<br />
consumer gear. These connectors have floating grounds.<br />
1.3.9 Opt In Connector<br />
This optical connector is linked to the <strong>Digital</strong> 4 button. It accommodates PCM audio at 96,<br />
48, 44.1, and 32 kHz (16, 20, and 24 bits) and <strong>Dolby</strong> <strong>Digital</strong> at all data rates and sample rates.<br />
1.3.10 NonSync Input Connector<br />
2 RCA jacks labeled L and R that accept 3 V RMS<br />
maximum input.<br />
1.3.11 Aux Out Connectors<br />
These analog output represents channel pair 7/8 of the 4xAES input.<br />
For the top output labeled 7, the source is Channel 7 of the 4xAES input. No equalization<br />
or level control is applied.<br />
For the lower output labeled 8, the source is Channel #8 of the 4xAES input. No<br />
equalization or level control is applied.<br />
8 <strong>Dolby</strong> ® <strong>CP750</strong> <strong>Digital</strong> <strong>Cinema</strong> <strong>Processor</strong> <strong>Manual</strong>