Installation & Setup User Guide - Best Access Systems

I: The License Server
setting, it was written into both the ACS.INI file AND the
…B.A.S.I.S.\LicenceServerConfig\Server.Properties file. This file is only
created during the install if the port setting was changed. If you want to
change the port setting in the ACS.INI file after the installation (either to a
new setting or back to 8189), then you must also change it in the
Server.Properties file.
License Server Procedures
Running the License Server from the Command Line
1. Click the Windows Start button, then select Command Prompt.
2. Change to the directory that contains the License Server executable. This is
the directory where you installed B.A.S.I.S., which is C:\Program
Files\B.A.S.I.S. by default.
3. Run the command LicenseServer -interactive. This will start the License
Server.
4. To stop the License Server, press CTRL-C.
Running the License Server in Windows
1. Click the Windows Start button, then select Programs > B.A.S.I.S. ET >
License Server.
2. The License Server will start. There is no visual indication that the License
Server is running, but the LicenseServer.exe process will be listed in the
Task Manager on the Processes tab.
Determining if the License Server is Running
1. In Windows, hold down , , consecutively, so that they
are all pressed at the same time.
2. The Windows Security window will open. Click [Task Manager…].
3. The Windows Task Manager window will open.
4. Click the Processes tab.
5. If the LicenseServer.exe process is listed in the window, then the License
Server is running. If LicenseServer.exe is not listed, then it is not running.
250 — revision 143