Installation & Setup User Guide - Best Access Systems

Installation & Setup User Guide
cameras), a cable must be run from the switcher to each CCTV video camera
and each camera must be output video in the same format.
Step 2: Set Up the FlashPoint Board
If you’re using a FlashPoint ISA or FlashPoint PCI board and are setting up a
capture station with flash, verify that the flash jumpers on the FlashPoint board
are set to use the Universal flash sync setting, as directed in Appendix A of your
Integral Technologies FlashPoint User’s Manual.
Step 3: Install the FlashPoint Video Capture Board
Install the FlashPoint board into the computer as directed in your Integral
Technologies FlashPoint User’s Manual. Make sure your computer boots
properly when you are done. In the event of a problem, first consult the
Troubleshooting chapter of the FlashPoint User’s Manual before contacting your
BEST customer service representative.
Step 4: Install the FlashPoint VGA Display Adapter
Driver (Windows 2000)
Shut down all currently running applications and make sure you have the correct
Windows VGA display adapter driver installed:
1. Start the Windows Control Panel.
2. Double-click the Display program icon. The Display Properties folder will
appear.
3. Click the Settings tab to switch to the Settings form.
4. Click [Display Type...]. The Display Type window will appear.
5. If your FlashPoint board is a FlashPoint ISA, FlashPoint Lite PCI or
FlashPoint PCI board, verify that the Adapter Type field indicates either
“Tseng Labs ET4000 W/32” or “Integral Technologies FlashPoint”. If your
FlashPoint board is a FlashPoint Lite 128 or a FlashPoint 128 board, verify
revision 143 — 253