Installation & Setup User Guide - Best Access Systems

4: CCD/CCTV Video Setup
Hardware included with different image capture packages
CCP601 Digital Zoom
1/4 inch color CCD camera
with autofocus/Iris 32X zoom lens
450 lines
S-Video camera with built-in
16X AF lens
Fixed diffused light with tilt head
Camera and light 110 VAC power supplies
Camera and light 220 VAC power supplies
S-Video Cable 12-foot length
Image capture card
USB adapter kit
Tripod with pan tilt mounts
Tripod with pan tilt mounts with
European plugs and cables
CAM-CCP500K X X X X X X X X X
CAM-CCP500K-EU X X X X X X X X X
CAM-500K-USB X X X X X X X X X
CAM-500K-USB-EU X X X X X X X X X
Note:
This chapter is for configuring the CAM-CCP500K and CAM-CCP500K-
EU. To configure the CAM-500K-USB or the CAM-500K-USB-EU, please
refer to Chapter 5: CCD/CCTV Video Setup for USB Devices on page 65.
• Replacement fixed diffused light with power supply.
• DPS060200-P5: Replacement camera power supply for CAM-CCP-500K.
• EHK-K42U-A Professional Continuous Lighting Kit: Two 600-watt
quartz lights, two bounce back white umbrellas, two stands, mounting
brackets and carrying case.
If you’re setting up a CCTV video station you need the following hardware:
• CCD Video camera: The camera must output video in one of the following
formats:
– RGB: The FlashPoint Lite 3D and FlashPoint 3D Plus do not support
this format.
– NTSC S-Video
– NTSC Composite
– PAL S-Video
– PAL Composite
• Video cable(s) and possible CCTV switcher: The cable(s) needed depend
on the model of FlashPoint board you have, the number of CCTV cameras
the computer is supposed to connect to and the video format being used. The
54 — revision 143