Installation & Setup User Guide - Best Access Systems

Installation & Setup User Guide
• Direct connection to the COM port
• 38400 bits per second (bps)
• 8 data bits
• NO parity
• 1 stop bit
• NO flow control
To do this using HyperTerminal:
1. Click the Windows Start button, then select Programs > Accessories >
Communications > HyperTerminal.
2. Type SafeNet Speed as the Name of the connection.
3. Select an icon to represent the connection, then click [OK].
4. In the Connect Using dropdown listbox, select the COM port of the
workstation that the SafeNet Speed box is connected to, then click [OK].
• In the Bits per second field, select ‘38400’.
• In the Data bits field, select ‘8’.
• In the Parity field, select ‘None’.
• In the Stop bits field, select ‘1’.
• In the Flow Control field, select ‘None’.
5. Close HyperTerminal.
• When prompted, click [Yes] to disconnect the session.
• When prompted, click [Yes] to save the session.
6. Reopen the session by clicking the Windows Start button, then selecting
Programs > Accessories > Communications > HyperTerminal > SafeNet
Speed session.
7. Press , and information will appear in the window.
8. Press and then press to enter the Configuration menu.
9. Type IRE as the initial password and press .
10. Press to create a new password.
11. Enter the new password and press .
12. Enter the new password again and press .
13. For each item, enter the following value if not already selected:
Item
Encryptor operating mode
Encryptor type
IP processing mode
Non-IP processing mode
Level 2 bridging
Value
Public Key
Host encryptor
FILTER
BYPASS
DISABLED
revision 143 — 303