Installation & Setup User Guide - Best Access Systems

Installation & Setup User Guide
FlashPoint/MCI Video Settings Form
Section/Field
Video Board
Input Format
Input Standard
Value
FlashPoint
S Video
NTSC
Video Source 1
Alternate Sync Mode
High Resolution Capture
Flash Type
Flash Field Delay
unchecked
checked
None
N/A
The video board name to use for the FlashPoint 3D/3Dx is just “FlashPoint.” (The
capture dialog auto-detects which type of FlashPoint board you have installed.)
FlashPoint/MCI Video I/O Settings Form
Field
Value
Flash Brightness 539
Flash Contrast 555
Live Brightness 539
Live Contrast 555
Hue 0
Red
Green
Blue
N/A
N/A
N/A
Saturation 507
Sharpness 0
Gain
Gamma
Offset
Video Output Settings
N/A
N/A
N/A
N/A to FlashPoint boards
If your situation requires that you configure these settings yourself, you must
click [Save User Defaults] to save the settings. Note that BadgeDesigner has its
own set of Multimedia Capture module settings apart from the set shared by ID
CredentialCenter and System Administration.
revision 143 — 61