Installation & Setup User Guide - Best Access Systems

3: Installing B.A.S.I.S. ET Third Edition
2. Install the USB hardware key by doing the following:
a. Attach the USB hardware key to any available USB port.
b. The Found New Hardware wizard starts. Click [Next].
c. The hardware is detected, and the Found New Hardware wizard
completes. Click [Finish]. The hardware key is now configured and
ready to be used.
3. Depending on your configuration, you may need to restart your PC so that
License Administration recognizes the hardware key. Otherwise, you may
receive an error in License Administration saying that the necessary
hardware device was not found.
50 — revision 143