Installation & Setup User Guide - Best Access Systems

Installation & Setup User Guide
E-mail/Paging Setup Checklist
The following steps are necessary to install and configure WirelessOffice
Messaging Software for use with B.A.S.I.S.:
1. Install B.A.S.I.S. ET Third Edition. For more information, refer to Chapter
3: Installing B.A.S.I.S. ET Third Edition on page 41.
2. Run Database Setup. For more information, refer to Appendix C: The
Database Setup Program on page 213.
3. Install WirelessOffice. For more information, refer to Install WirelessOffice
Messaging Software on page 93.
4. Configure WirelessOffice for use with the B.A.S.I.S. software.
• Configure the modem. For more information, refer to Configure the
Modem on page 98.
• Configure the carrier that will be used. For more information, refer to
Configure the Carrier on page 99.
• Test connectivity. For more information, refer to step 9 on page 101.
• Verify that the “File Messenger” and “WirelessOffice Server” services
are started and automatic. For more information, refer to step 7 on page
101.
5. In System Administration, configure B.A.S.I.S. for use with WirelessOffice.
• Set up a paging device or devices. For more information please refer to
“Add a Paging Device” in the Global Output Devices Folder chapter in
the System Administration User Guide.
• Create a recipient. For more information please refer to “Add a
Recipient” in the Global Output Devices Folder chapter in the System
Administration User Guide.
6. Set up manual paging, and then verify that the “LS Global Output Server”
service is started and automatic. For more information, refer to Set Up
Manual Paging on page 103.
7. (Optional) Set up automatic paging. For more information, refer to Set Up
Automatic Paging on page 103. If automatic paging is not set up, manual
paging can still be done.
8. Verify that the “LS Linkage Server” service is started and automatic. For
more information, refer to Set Up Automatic Paging on page 103.
revision 143 — 91