Installation & Setup User Guide - Best Access Systems

Installation & Setup User Guide
most common cable is # HOC-3610, expanded cable [RGBS (DB-9)]
composite, S-Video, photo coupler.
Note:
Although FlashPoint boards have multiple video inputs (the number depends
on the model of FlashPoint board), Alarm Monitoring stations are
configured to use only one FlashPoint video input at a time. Therefore, if a
monitoring station is to use multiple CCTV video cameras, the FlashPoint
board must be connected to a CCTV switcher (instead of directly to the
cameras), a cable must be run from the switcher to each CCTV video camera
and each camera must be output video in the same format.
Step 2: Install the FlashPoint Video Capture Board
Install the FlashPoint board into the computer as directed in your Integral
Technologies FlashPoint User’s Manual. You will need to install the FlashPoint
card into PCI slot 1. Make sure your computer boots properly when you are done.
If you installed the FlashPoint video capture board on the Dell Optiplex GX260,
you must disable the onboard Intel 82845G/GL Graphics Controller. To do this:
1. Start the computer up in VGA mode.
2. Delete the following drivers:
• C:\\WINNT\system32\drivers\a302.sys
• C:\\WINNT\system32\drivers\a303.sys
• C:\\WINNT\system32\drivers\a304.sys
• C:\\WINNT\system32\drivers\a305.sys
• C:\\WINNT\system32\drivers\a306.sys
• C:\\WINNT\system32\drivers\a307.sys
• C:\\WINNT\system32\drivers\a308.sys
• C:\\WINNT\system32\drivers\a309.sys
• C:\\WINNT\system32\drivers\ialmkchw.sys
• C:\\WINNT\system32\drivers\ialmnt.sys
• C:\\WINNT\system32\drivers\ialmsbw.sys
• C:\\WINNT\system32\drivers\vch.sys
• C:\\WINNT\system32\drivers\wa301a.sys
• C:\\WINNT\system32\drivers\wa301b.sys
• C:\\WINNT\system32\drivers\wa310a.sys
• C:\\WINNT\system32\drivers\wa310b.sys
3. Restart the computer.
4. In the Device Manager, disable the Intel 82845G/GL Graphics Controller.
revision 143 — 55