ijpds formats.book - Kodak

Appendix A. Record References
Table A.1 Records by acronym
Record
Acronym
Control
Code
A - 2 IJPDS Formats
Name Page Description
BOX 27 Fill a Rectangular Area 4-51 Fills a specified area with a black or white fill pattern.
CBM 3E Compressed Bitmap 4-53 Contains compressed bitmap to be printed.
Interchangeable with the IBM.
CCD 3D Compressed Character
Definition
CDM 30 Character Definition with
Metrics
4-18 Defines each character in a category I font. Contains a
compressed bitmap pattern for the character.
Interchangeable with the CDM.
4-15 Defines each character in a category II font. Contains a
bitmap pattern for the character. Interchangeable with the
CCD.
CDR 14 Character Definition Record 4-23 Defines each character in a category I font. Contains a
bitmap pattern for the character.
CSR 37 Cursor Restore 4-37 Restores the cursor to a position saved by the CSS
record.
CSS 36 Cursor Save 4-36 Saves the current absolute cursor position for later
retrieval by the CSR record.
EFF 02 End Fixed Files 4-26 Indicates end of fixed files.
EOJ 09 End of Job 4-62 Indicates end of job. Can contain a message for display.
FAR 25 Font Assignment Record 4-10 List fonts needed for the job and assigns font numbers to
font names.
FDR 13 Font Definition Record 4-22 Contains general information about a category I font.
Followed by CDRs.
FDM 2E Font Definition with Metrics 4-14 Contains general information about a category II font.
Followed by CDMs and/or CCDs.
GFF 0F Go to Fixed File 4-45 Identifies records in current fixed file to be executed.
IBM 29 Image Bitmap 4-52 Contains bitmap to be printed. Interchangeable with the
CBM.
IML 0C Image a Line 4-41 Contains one line of print. Uses last identified font and
ILS.
JC2 24 Job Control Record 2 4-5 Used for all KODAK VERSAMARK printing systems except
DS2900. Must be the first record in a job file.
JCR 00 Job Control Record 4-63 Used only for KODAK VERSAMARK DS2900 printing
systems. Must be the first record in a job file.
LFF 01 Load Fixed Files 4-25 Indicates that a fixed file follows this record.
MPL 35 Multi-Part Line Mode 4-43 Allows the printing of more than one SFI, IML, SIL, or UIL
record on a line.
MSG 0A Message 4-59 Contains a message for display.
NOP 22 No Operation 4-61 Used to remark out a record.
PHR 26 Printhead Requirements
Record
4-8 Specifies the number and type of printheads required for
the job.
PLR 3B Page Length Requirement 4-12 Specifies the page length requirement for the current RIP.
RCR 32 Range Check Record 4-27 Sets boundary limits for the four sides of the page buffer.
RFF 0E Reset Fixed File 4-46 Identifies fixed file and records to be executed after
pointer is first reset to start of file.
RIP 23 Select RIP 4-7 Specifies which RIP is to receive subsequent data.
RSRC 3F Remote Resource 4-54 Directs the data system to read a sequence of IJPDS
records from a remote resource file.