ijpds formats.book - Kodak

Table A.2 Records by control code (Continued)
Control
Code
Record
Acronym
Name Page Description
26 PHR Printhead Requirements
Record
Appendix A. Record References
4-8 Specifies the number and type of printheads required for
the job.
27 BOX Fill a Rectangular Area 4-51 Fills a specified area with a black or white fill pattern.
28 SLF Set Logical Function 4-49 Defines how new pixels will combine with old pixels.
29 IBM Image Bitmap 4-52 Contains bitmap to be printed. Interchangeable with the
CBM.
2A SFD Super Font Definition 4-17 Contains general information about a category I super
font. Followed by FDRs and CDRs.
2B SIL Two-Byte Image Line 4-42 Contains double-byte text. Using current super font,
specifies subfonts and characters.
2C SFT Set Font 4-39 Sets font or super font for following records.
2D VCC Verify Character Checksum 4-60 Compares checksum in this record against current page
checksum calculated by system.
2E FDM Font Definition with Metrics 4-14 Contains general information about a category II font.
Followed by CDMs and/or CCDs.
2F SFM Super Font with Metrics 4-13 Contains general information about a category II super
font. Followed by FDMs, CDMs, and/or CCDs.
30 CDM Character Definition with 4-15 Defines each character in a category II font. Contains a
Metrics
bitmap pattern for the character. Interchangeable with the
CCD.
31 SFS Set Font and Spacing 4-38 Sets font or super font and spacing for following records.
32 RCR Range Check Record 4-27 Sets boundary limits for the four sides of the page buffer.
33 UIL Unformatted Image Line 4-47 Permits printing of a portion of a stored image string.
34 SOR Set Origin 4-34 Sets the origin to the current cursor position.
35 MPL Multi-Part Line Mode 4-43 Allows the printing of more than one SFI, IML, SIL, or UIL
record on a line.
36 CSS Cursor Save 4-36 Saves the current absolute cursor position for later
retrieval by the CSR record.
37 CSR Cursor Restore 4-37 Restores the cursor to a position saved by the CSS
record.
38 SRP Set Relative Position 4-35 Sets a new cursor position relative to the current cursor
position.
39 SRM Set Resolution Multiplier 4-11 Sets the logical resolution of the current RIP. Allows data
prep to use higher resolution for distance parameters.
3A SPL Set Page Length 4-55 Sets current page length. Can be shorter or longer than
actual image data for the page.
3B PLR Page Length Requirement 4-12 Specifies the page length requirement for the current RIP.
3C SPX Set Position Extended 4-33 Sets the X and Y position for following data (32-bit
position fields).
3D CCD Compressed Character 4-18 Defines each character in a category I font. Contains a
Definition
compressed bitmap pattern for the character.
Interchangeable with the CDM.
3E CBM Compressed Bitmap 4-53 Contains compressed bitmap to be printed.
Interchangeable with the IBM.
3F RSRC Remote Resource 4-54 Directs the data system to read a sequence of IJPDS
records from a remote resource file.
Reference Guide A - 5