ijpds formats.book - Kodak

Table A.1 Records by acronym (Continued)
Record
Acronym
SDC 05
11
Appendix A. Record References
Start of Document and Cue 4-28 Starts new document after waiting for a cue. Code 11 is
for security version.
SFD 2A Super Font Definition 4-17 Contains general information about a category I super
font. Followed by FDRs and CDRs.
SFF 0D Set Fixed File 4-44 Identifies fixed file and records to be executed.
SFI 0B Set Font and Image 4-40 Identifies the font and ILS and contains characters for
one line of print.
SFM 2F Super Font with Metrics 4-13 Contains general information about a category II super
font. Followed by FDMs, CDMs, and/or CCDs.
SFS 31 Set Font and Spacing 4-38 Sets font or super font and spacing for following records.
SFT 2C Set Font 4-39 Sets font or super font and spacing for following records.
SIL 2B Two-Byte Image Line 4-42 Contains double-byte text. Using current super font,
specifies subfonts and characters.
SLF 28 Set Logical Function 4-49 Defines how new pixels will combine with old pixels.
SOD 04
10
Control
Code
Name Page Description
Start of Document 4-30 Starts a new document without waiting for cue. Code 10
is for security version.
Note: The SOD record cannot be used with the CS200
and CS220 system controllers.
SOP 20 Start of Page 4-56 Starts a new page. Sets the X and Y starting point to the
top of the page (0,0).
SOR 34 Set Origin 4-34 Sets the origin to the current cursor position.
SPC 07 Space 4-48 Specifies dot rows of vertical space to be inserted.
SPL 3A Set Page Length 4-55 Sets current page length. Can be shorter or longer than
actual image data.
SPO 21 Set Position 4-32 Sets the X and Y position for following data (16-bit
position fields).
SPX 3C Set Position Extended 4-33 Sets the X and Y position for following data (32-bit
position fields).
SRM 39 Set Resolution Multiplier 4-11 Sets the logical resolution of the current RIP. Allows data
prep to use higher resolution for distances.
SRP 38 Set Relative Position 4-35 Sets a new cursor position relative to the current cursor
position.
STP 08 Stop 4-58 Stops printing. Can contain a message for logging.
UIL 33 Unformatted Image Line 4-47 Permits printing of a portion of a stored image string.
VCC 2D Verify Character Checksum 4-60 Compares checksum in this record against current page
checksum calculated by system.
WFC 06 Wait for Cue 4-57 Causes system to wait for next cue and start a new page.
Note: The WFC record cannot be used with the CS200
and CS220 system controllers.
Reference Guide A - 3