Untitled - Flannery Plant Hire

OPERATOR'S STATION
CAB DOOR RELEASE LEVER
CAUTION:
• Open the cab door all the way until it securely locks
in the latch on the side of the cab.
• Do not keep the cab window open when the machine
is parked on a slope, or while the wind is
blowing hard. The cab window may close accidentally,
possibly resulting in personal injury.
• When opening or closing the cab window, take
extra care not to catch fingers between the base
machine and the cab window.
To unlock the door from this position, push down on lever (1).
1
M1J1-07-051
OPENING UPPER FRONT WINDOW
WARNING: Open or close the upper-front cab window
only after pulling up the pilot control shut-off lever
to the LOCK position. Failure to do so may allow the
machine to move unexpectedly if a control lever is
touched with a part of the body by mistake, possibly
resulting in personal injury or death.
2
3
1. Press lock release lever (2) at the upper center to release
the upper front window lock.
M1U1-01-028
NOTE: Use caution when releasing the lock. The upper section
of the upper front window will move approx. 10 cm
inward.
2. Holding the upper and lower handles (one each) on the
upper front window, pull the upper front window up and
back until it securely catches into auto locks (4).
CAUTION: Always secure lock pin (3) in the lock position
after the upper front window is opened.
3. After confirming that the window securely catches into
auto locks (4), slide lock pin (3) into the left bracket boss
hole to lock the window in position.
M1CC-01-020
NOTE: When the upper front window is opened, the wiper and
washer are inoperable.
4
M1CC-01-031
1-70