ES4626-SFP Management Guide.pdf

no ipv6 rip split-horizon
Function: Permit the split horizon. The “no ipv6 rip split-horizon” disables the split
horizon
Parameter: [poisoned] configures split horizon with poison reverse.
Default: Split horizon with poison reverse
Command Mode: Interface Mode
Usage Guide: The split horizon is for preventing the routing loops, namely preventing the
layer 3 switch from broadcasting a route at the interface from which the very route is
learnt. The command can configure on IPv6 tunnel interface, but it is successful
configuration to only configure tunnel carefully.
Example: Switch# config terminal
Switch(config)# interface Vlan1
Switch(config-if-Vlan1)# ipv6 rip split-horizon poisoned
17.5.3.6 distribute-list
Command: [no]distribute-list{access-list-name> |prefix} {in|out}
[]
Function: This command uses access-list or prefix-list to filter the route renews
messages sent and received. The “[no]distribute-list{access-list-name>
|prefix} {in|out} []” command cancels this filter
function
Parameter: is the name or access-list number to be applied.
is the name of the prefix-list to be applied. specifies the
name of interface to be applied with route filtering
Default: Function disabled by RIPng by default
Command Mode: Router mode
Usage Guide: The filter will be applied to all interfaces if no specific interface is set.
Example: Switch# config terminal
Switch(config)# router ipv6 rip
Switch(config-router)# distribute-list prefix myfilter in Vlan1
17.5.3.7 ipv6 router rip
Command: ipv6 router rip
no ipv6 router rip
Function: Enable RIPng on the interface. The “no ipv6 router rip” command
disables RIPng on the interface.
Default: Not configured
Command Mode: Interface Mode
474