ES4626-SFP Management Guide.pdf

Priority is always 254 for IP Owner.
Parameters: < value> is the priority value, ranging from 1 to 254.
Default: The priority of all backup routers (or L3 Ethernet switch) in a Standby cluster is
100; the Master router (or L3 Ethernet switch) in all Standby cluster is always 254.
Command mode: VRRP protocol configuration mode
Usage Guide: Priority determines the ranking of a router (or L3 Ethernet switch) in a
Standby cluster, the higher priority the more likely to become the Master. When a router
(or L3 Ethernet switch) is configured as Master dummy IP address, its priority is always
254 and does not allow modification. When 2 or more routers (or L3 Ethernet switch) with
the same priority value present in a Standby cluster, the router (or L3 Ethernet switch)
with the greatest VLAN interface IP address becomes the Master.
Example: Setting VRRP priority to 150.
Switch(Config-Router-Vrrp)# priority 150
25.3.9 router vrrp
Commands: router vrrp
no router vrrp
Function: Creates/Removes the Virtual Router
Parameters: < vrid > is the Virtual Router number ranging from 1 to 255.
Default: Not configured by default.
Command mode: Global Mode
Usage Guide: This command is used to create/remove Virtual Router, which is identified
by a unique Virtual Router number. Virtual Router configurations are only available when
a Virtual Router is created.
Example: Configuring a Virtual Router with number 10
Switch(config)# router vrrp 10
25.3.10 show vrrp
Commands: show vrrp []
Function: Displays status and configuration information for the VRRP standby cluster.
Command mode: All Modes
Example:
Switch# show vrrp
VrId
State is Initialize
Virtual IP is 10.1.20.10 (Not IP owner)
903