ES4626-SFP Management Guide.pdf

[no] passive-interface {IFNAME |
ethernet IFNAME | Vlan }
Sets an interface to receive only, the [no]
passive-interface {IFNAME | ethernet
IFNAME | Vlan } command cancels
this configuration.
2. Configure OSPF protocol parameters
(1)Configure OSPF package sending mechanism parameters
1)Configure OSPF package verification
2)Set the OSPF interface to receive only
3)Configure the cost for sending packages from the interface
Command
Explanation
Interface configuration mode
Configures the authentication method by the
ip ospf authentication
interface to accept OSPF packages; the no ip
{ message-digest | null}
ospf authentication command restores the
no ip ospf authentication
default settings.
Configure the key of the authentication
ip ospf authentication-key LINE process of OSPF data packets receiving for
no ip ospf authentication-key the interfaces; the no action of this command
restores the default settings.
Sets the cost for running OSPF on the
ip ospf cost
interface; the “no ip ospf cost” command
no ip ospf cost
restores the default setting.
4)Configure OSPF package sending timer parameter (timer of broadcast interface
sending HELLO package to poll, timer of neighboring layer3 switch invalid timeout, timer
of LSA transmission delay and timer of LSA retransmission.
Command
Explanation
Interface configuration mode
Sets interval for sending HELLO packages;
ip ospf hello-interval
the “no ip ospf hello-interval” command
no ip ospf hello-interval
restores the default setting.
Sets the interval before regarding a neighbor
ip ospf dead-interval layer3 switch invalid; the “no ip ospf
no ip ospf dead-interval
dead-interval” command restores the default
setting.
488