ES4626-SFP Management Guide.pdf

Command
Port Mode
dot1x port-method
{ userbased | macbased |
portbased}
no dot1x port-method
dot1x
max-user
macbased
no dot1x max-user
macbased
dot1x max-user userbased
no dot1x max-user
userbased
dot1x guest-vlan
no dot1x guest-vlan
Explanation
Sets the port access management method; the “no
dot1x port-method” command restores MAC-based
access management.
Sets the maximum number of access users for the
specified port; the “no dot1x max-user macbased”
command restores the default setting of allowing 1
user.
Set the upper limit of the number of users allowed to
access the specified port, only used when the access
control mode of the port is userbased; the “no dot1x
max-user userbased” command is used to reset the
limit to 10 by default.
Set the guest vlan of the specified port; the “no dot1x
guest-vlan” command is used to delete the guest vlan.
3) Configure expanded 802.1x function
Command
Global Mode
dot1x macfilter enable
no dot1x macfilter enable
dot1x accept-mac
[interface
]
no dot1x accept-mac
[interface
]
dot1x eapor enable
no dot1x eapor enable
Explanation
Enables the 802.1x address filter function in the switch;
the "no dot1x macfilter enable" command disables
the 802.1x address filter function.
Adds 802.1x address filter table entry, the “no dot1x
accept-mac” command deletes 802.1x filter address
table entries.
Enables the EAP relay authentication function in the
switch; the “no dot1x eapor enable” command sets
EAP local end authentication.
3. Supplicant related property configuration
Command
Explanation
852