Toshiba B-EX4T1 Owners Manual - The Barcode Warehouse

2.PRINTER SETUPENGLISH VERSION EO1-330892.10 Threshold Setting2.10 Threshold Setting(Cont.)NOTE:To make a threshold value setin this section effective, selectthe Transmissive Sensor (whenusing pre-printed media) orReflective Sensor (when usingmanual threshold value) inIssue Command or the printerdriver.Display example Explanation1 Result: OK (Mid.)Threshold is at the midpoint between thepeak and the baseline.2 Result: OK (High)Threshold is near the peak voltage.Adjusting the threshold to the midpointbetween the peak and the baseline enablesmore accurate detection.3 Result: OK (Low)Threshold is near the baseline voltage.Adjusting the threshold to the midpointbetween the peak and the baseline enablesmore accurate detection.4 Failed (1)The media sensor cannot detect a gap/blackmark. Sensor adjustment is required.(⇒Section 2.11)5 Failed (1)The media sensor cannot detect a gap/blackmark. (Threshold ≤ Baseline) Sensoradjustment is required. (⇒Section 2.11)6 Failed (2)Detection by the media sensor is disabled.Sensor adjustment is required. (⇒Section2.11)(5) Press the [RIGHT] to see the details.NOTE:The threshold can be manuallyset as follows:Manually set threshold =Peak voltage – Threshold fineadjustment valuee.g.) When Peak=3.5V andFine adjustment value=1.0V,the threshold will be set to2.5V.(e.g: Succeeded)(e.g.: Failed)Sensor typePeak voltageThreshold voltageBaseline voltageKey operation guide(6) To return to the previous display, press the [LEFT].To adjust the threshold, press the [RIGHT]. The threshold fineadjustment screen in ADJUST SET menu appears.Set a value and press the [ENTER].(7) The result after manually setting the threshold is displayed.E2-68