Merlins Ralliart and EvoX TUNING GUIDE Version K.pdf - EvoScan
Merlins Ralliart and EvoX TUNING GUIDE Version K.pdf - EvoScan
Merlins Ralliart and EvoX TUNING GUIDE Version K.pdf - EvoScan
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MERLINS RALLIART & EVOLUTION-X <strong>TUNING</strong> <strong>GUIDE</strong>3.02-OBD-II DIAGNOSTIC CONNECTORThe connector is behind the dash facia, drivers side, just out-board of the steeringcolumn on the EVOX <strong>and</strong> RALLIART. Just feel with your h<strong>and</strong> <strong>and</strong> plug theOpenPort2 cable into the 16 pin socket.The OBD-II specification provides for a st<strong>and</strong>ardized hardware interface, SAE J1962defines the pin-out of the connector as:Table 2OBDII CONNECTOR PIN FUNCTIONDESCRIPTION PIN # DESCRIPTION8 16 BATTERY VOLTAGEECU - K line 7 15 L line of ISO9141-2 & ISO14230-4CAN high ISO15765-4 & SAE-J2234 6 14 CAN low ISO15765-4 & SAE-J2234SIGNAL GROUND 5 13CHASSIS GROUND 4 123 11Bus positive line of SAE-J1850 2 10 Bus negative line of SAE-J18501 9 ETACSNote that it is now considered a good idea to remove pin 9 from the OpenPort2cable to prevent damage to the ETACS ECU. Pin 9 is only used for flashing SubaruECUs.REV: 0.K merlin@three.com.au Page 31 of 134