Merlins Ralliart and EvoX TUNING GUIDE Version K.pdf - EvoScan

MERLINS RALLIART & EVOLUTION-X TUNING GUIDEThis next set of procedures will involve some adjustment to the values in your MAFscaling, so that the final WOT AFR is a close match to what is tabled in your fuelmap.1. Save you current bin file, with your working fuel maps.2. Open the HI OCTANE FUEL MAP in EcuFLASH, highlight/select all the cells at 120load and above set to =11.5.3. Disable LEAN SPOOL by setting the start rpm to 7500rpm.4. Start the car and allow the engine to reach operating temperature.5. Run the car into some low level of boost ie above load 120. Keep the boost levelsto less than 12 psi preferably. Have EvoScan logging Airflow Hz. Hint, turn offeverything else except rpm and load. Compare and record the air fuel ratio readingto the set 11.5 value. If the error is less 0.2 then maybe you wouldn’t bother withany further adjustments and just note the offset and allow for it. If more than 0.2and you want to dial it out, proceed on.6. Calculate the percentage error between the actual and mapped AFR. I will use12.0 AFR as an example. This value is -4.17% (lean) from where it needs to be.7. Open the AIRFLOW Hz / RAW SCALING table in EcuFlash. If the log indicates thatat or about 300Hz the actual AFR was 12.0, that is the cell we will modify first. Thecorresponding value at 300Hz is 208.Now increment this number by 4.17%208 * 1.0417 = 216.68. Highlight all the cells above 300. Increment them all using the ] key until the300 cell value 216. Smooth the cells below 300 so the curve is even. Leave thecells in the idle area alone.9. Re-load your desired or original fuel maps back into the ECU with your newINJECTOR SIZE SCALING value. Reset LEAN SPOOL start rpm to the correct value.Useful tip: put Min Coolant Temp for Closed Loop extremely high to disable closedloop while measuring mixture on idle. An alternative method of disabling closedloop is to disconnect the front O2 sensor, though this will seen by the ECU as afault condition.In theory fuel economy during closed loop should be the same for any trim, seeingthat the ECU is trying to keep a stoich 14.7:1. Different trims are just going tochange the transitional AFRs from closed to open loop a small amount.If you are having trouble with stumbling while the car is still cool, but the car hasnot gone into closed loop, then you have to make some minor adjustments to thefuel maps or the warm-up enrichment parameters.REV: 0.K merlin@three.com.au Page 95 of 134