Range Rover Workshop Manual - Eng - Landiesrus

LAND ROVER V820. Remove 6 remaining bolts securing water pumpto cover. Remove water pump and gasket.21. Remove oil pressure switch.22. Remove bolt securing camshaft sensor. Removesensor from front cover.23. Ensure mating faces of camshaft sensor andfront cover are clean.24. Refit sensor.25. Refit sensor bolt. Tighten to 8 Nm (6 lbf.ft)26. Ensure thread of oil pressure switch is clean.27. Refit switch to front cover. Tighten to 15 Nm (11lbf.ft)28. Ensure water pump, its mating face, dowel anddowel hole are clean.29. Refit water pump and new gasket.30. Refit water pump bolts. Tighten to 22 Nm (16lbf.ft)A- Early type sealB- Later type seal - use as replacement for allcovers34. Lubricate new front cover oil seal with ShellRetinax LX grease ensuring that space betweenseal lips is filled with grease.CAUTION: Do not use any other type ofgrease.35. Using LRT-12-089, fit seal to cover.Refit31. Ensure cover, its mating face, dowels and dowelholes are clean.32. Ensure crankshaft and oil pump mating facesare clean.33. Ensure oil seal register in cover is clean.REPAIR27