Range Rover Workshop Manual - Eng - Landiesrus

12ENGINE NEW RANGE ROVERFRONT COVER AND OIL PUMP ASSEMBLYService repair no - 12.60.26Remove1. Remove front cover gasket See this section.Refit6. Ensure oil filter cartridge adaptor thread is cleanand apply Loctite 577 sealant to thread.7. Ensure oil pressure switch and mating face isclean.8. Fit new ’O’ ring and tighten switch to 15 Nm (11lbf.ft).9. Clean water pump and mating face.10. Use a new gasket and fit water pump. Tightenbolts securing water pump to 22 Nm (16 lbf.ft).11. Ensure CMP sensor is clean, fit new ’O’ ring andfit sensor to cover.12. Fit clamp to CMP sensor and tighten bolt to 8Nm (6 lbf.ft).13. Fit front cover gasket. See this section.2. Remove bolt securing CMP sensor, removeclamp and sensor. Discard ’O’ ring.3. Remove 6 bolts securing water pump, removepump and discard gasket.4. Remove oil pressure switch and discard ’O’ ring.5. Remove oil filter cartridge. See this section.32 REPAIR