Range Rover Workshop Manual - Eng - Landiesrus

LAND ROVER V816. Loosen unions and disconnect oil cooler feedand return pipes from front cover , remove anddiscard ’O’ rings.CAUTION: Plug the connections.17. Remove 9 bolts securing front gear cover andremove cover. Remove and discard gasket.Refit21. Fit new ’O’ rings to oil cooler pipes, connectpipes to front cover and tighten unions to 15 Nm(11 lbf.ft).22. Fit bolt securing oil cooler return pipe toalternator mounting bracket.23. Connect Lucar to oil pressure switch.24. Connect multiplug to CMP sensor.25. Ensure oil filter seal and mating face on frontcover is clean.26. Lubricate seal with clean engine oil and fitengine oil filter.27. Fit radiator cowl and secure with clips.28. Fit oil cooler pipes into recesses in radiator cowland tighten pipe unions to 30 Nm (22 lbf.ft).29. Fit thermostat housing to radiator cowl.30. Connect bottom coolant hose to radiator andsecure with clip.31. Connect hose to water pump and secure withclip.32. Connect top hose to radiator and secure withclip.33. Ensure mating faces of water pump pulley anddrive flange are clean, fit pulley and tighten boltsto 22 Nm (16 lbf.ft).34. Fit auxiliary belt jockey pulley and tighten bolt to50 Nm (37 lbf.ft).35. Fit front cover oil seal. See this section.36. Fit oil pick-up strainer. See this section.37. Refill cooling system. See COOLING SYSTEM,Repair.18. Clean mating faces of front cover and cylinderblock. Clean dowels and dowel holes.19. Fit new gasket onto dowels in cylinder block.20. Fit front cover to cylinder block and tighten boltsin sequence shown to 22 Nm (16 lbf.ft). EnsureCMP sensor multiplug bracket is secured by bolt.REPAIR31