Range Rover Workshop Manual - Eng - Landiesrus

LAND ROVER V8Refit6. Ensure all mating surfaces are clean.7. Fit spacer and hub aligner to crankshaft.8. Fit hub aligner screws. Tighten to 85 Nm (63lbf.ft)9. Fit drive plate and clamp ring.10. Fit clamp ring bolts. Tighten to 45 Nm (33 lbf.ft)11. Fit automatic gearbox and converter assembly.See AUTOMATIC GEARBOX, Repair.DRIVE PLATE - AUTOMATIC - from 99MYService repair no - 12.53.13Remove1. Remove gearbox. See AUTOMATICGEARBOX, Repair.2. Remove CKP sensor. See FUEL SYSTEM,Repair.3. Remove Lucar from starter solenoid.4. Remove nut securing battery lead to startersolenoid and disconnect lead.5. Remove 2 Allen screws securing starter motorand remove starter motor.6. Remove 4 bolts securing drive plate clamp ringand remove ring.7. Remove drive plate from hub.8. Remove spacer.9. Remove starter ring gear.REPAIR5